

Pictured are 2 EVH reels. On the left is an early 2 1/2" diameter half handle example which was marked in the hard rubber, not on the bearing cover, as were some early EVH reels. On the right is an EVH 355 size 3 1/2 which is marked on the foot 355 and 3 1/2 but rather than the typical sliding cover on the back plate there is a bearing cap. At first I thought that the back plate from JVH reel had been switched out. However, under closer examination I found that the click button, it's location, and the location of the screws for the click spring assembly were the same as all EVH 355's.



