ISO Cozzone check spring

[klonder]

Hoping to find a caliper spring for a 2-1/4" Cozzone 60yd fly reel. Fortunately, Cozzone saw fit to used screws to attach the spring making for easy removal/replace.
Any help most apprieciated.

[klonder]

Bueller??? Bueller???
Or maybe sugestions as to repair? Not a "fisher" but nice to make it functional although only a "display" reel.

[john elder]

I’ll see what i can find. Got lots of click springs but trick is to find right size. I had to replace one on one of mine, so will compare. These little buggers were hard on springs, for some reason!!

John

[klonder]

Thanks John. It's just about 1" dia. No worries about the holes as I can drill and tap np, but would need the flange for sure.
Cheers

[john elder]

Steve, what i have is smaller for most part… one possible. I still have your address from a past deal so will send for yoi to try unless you found one.

J

[klonder]

Thanks again John for your help. Been mulling over thoughts of a bit of the right sort of wire and solder. I doubt I'll find an original replacement.

[RonG]

I found these in the Drawer Maze I have. Let me know if you could use one.

[klonder]

Thanks for the offer Ron. Unfortunately they are all too small. I need a 1" dia spring to fit correctly.