Meisselbach Two Screw Tri-Part rear bearing issues - HELP!

FLpanther · Post by **FLpanther** » Sun May 30, 2010 2:49 pm

This is my first ORCA post! I recently decided to purchase a nice little reel for a circa 1907 Bristol rod that I have (I primarily collect pre-1910 metal lures - this is my first reel purchase) - it is a Meisselbach Two Screw Tri-Part reel. It arrived in the mail yesterday and everything seems to be fine - EXCEPT the rear bearing knob on the exterior of the reel appears to be stuck and will not unscrew (I would like to lessen the pressure that is being exerting on the spool a little bit). Is there a trick to unscrewing these? Do you have to pull on the knob first, then unscrew it? Is the knob reverse threaded? It does not outwardly appear that the reel has been dropped - causing damage to the knob/rear bearing. This is my first vintage reel purchase, I really like this reel and do not want to screw it up. I would greatly appreciate ANY information/help with this. Thanks! John

Jeff Johnson · Post by **Jeff Johnson** » Sun May 30, 2010 3:25 pm

It should just unscrew counterclockwise. Try some penetrating oil on it and let it soak in for a bit. If I need to use pliars I put a piece of leather around whatever Im working on so I dont ruin what Im working on. Good luck, Jeff

FLpanther · Post by **FLpanther** » Sun May 30, 2010 4:22 pm

WOW! I used penetrating oil, a strip of leather and a pair of pliars... It unscrewed like magic! I was afraid to man-handle such a small/old reel. I really appreciate your advice! John